sitelogo
 Home»Electrical Electronics Engineering» Construction of a car touch intruder alarm

Construction of a car touch intruder alarm

 Department: Electrical Electronics Engineering  
 By: usericon francis05  

 Project ID: 683
   Rating:  (2.9) votes: 18
Rate this project
   Price:₦3000
Abstract
The main objective of this project was to ensure proper security to a car being parked in a garage against theft or an intruder. The circuit uses three NE555 timers one of the NE555 was wired as a monostable oscillator and the remaining two were wired as a tone generator and amplified to obtain a maximum audible sound. However, pin 2 of the first NE555 was used as a sensor part.W hen pin 2 has contact with the human body or hand it will activate the IC1 which will also bias transistor and this transistor was wired in a way that once it is powered it will close circuit thereby passing a negative supply voltage to tone generator circuit and outputted out through a loudspeaker or buzzer. This device functions as a major security device against car-theft as stated above. It is an electronic device that is connected to the battery of the car it is being installed in and gets activated when the car engine is switched off and the car stationed at a place. The device is not seen but, it has an indicator light which shows that the alarm has been activated. When the body of the car is touched by human hand, it sends a negative signal to the device which needs a negative pulse to get activated it sends this negative from the human hand to the tone generator IC which triggers the alarm.     ...
Preview +
Other Electrical Electronics Engineering project topics and materials you might be interested in

Upload Project

Do you have project materials to share? Upload and earn with it.

Departments