Strength properties of fiber reinforced concrete produced from demolition waste Department: Building Technology By: Expresshubpub Project ID: 2201 Rating: (3.0) votes: 22Rate this project12345 Price:₦3000 Get the Complete MaterialAbstractThe study focused on the strength properties of fibre-reinforced concrete produced from building demolition waste, which aims at accessing the suitability of fiber reinforced concrete produced from demolition waste. Tensile and compressive strength of 19mm aggregate size of coarse aggregate of 0% of all in aggregate and addition of 0.7% and 0.14% of filament fibre which 12 cubes were produced from each aggregate size of 19mm and addition of 0.7% and 0.14% of filament fibre each. For each cast of cube, cube size of 100mm by 100mm cube was used and cylinder of 100mm by 200mm were cast for s7 days, 14 days, 21 days and 28 days respectively using the mix ratio of 1:6 and water-cement ratio of 0.5, test showed that the workability tensile and compressive strength of an all in aggregate of 0%, it shows that it maximum strength is 1.95N/mm2 and 17.80N/mm2 at 28 days which is more higher than tensile and compressive strength of filament fiber of 0.7% and 0.14% which, the 0.7% tensile and compressive strength is 1.88N/mm2 and 9.74N/mm2 at 28 days respectively and that of the 0.14% for tensile and compressive strength is 1.65N/mm2 and 9.20N/mm2 at 28 days respectively. It is recommended that 0.7% of filament fibre should be adopted as mass concrete construction where the low bearing structure is required. ...Preview Download Preview +Other Building Technology project topics and materials you might be interested in»Causes of project abandonment in building construction industry and remedial measures»Causes of construction project failures and abandonments in Nigeria»Safety procedures and accident prevention methods in construction sites»Control of Noise Pollution and Sound Insulation in Buildings ( A Case Study of a Broadcasting Studio)»The implication and benefit of the use of softwares in building project construction (case study of selected software and firm)»Maintenance and servicing problems of specialist works in building»The effect of quality control in the building construction process (a case study of Afikpo, Ebonyi state)»A study of prospects and problems of timber as external material in building production in hot climate region»The impact of budgeting and budgetary control in construction project delivery in Nigeria»Challenges of low-cost housing delivery in Nigeria (Case study of Imo state)»Use of formwork design and construction of high building»Project planning and programming as tools for effective project delivery»The use of building survey for maintenance of building in Nigeria ( A case study of one storey building at Owerri, Imo state)»Design and construction of office complex for school of environmental design technology»Effects of labour management in building construction site - case study of Owerri, Imo state